Bulb Seal Gasket

Description:

Over time a camper's Bulb Seal can degrade. This can occur due to weather and UV damage, or we have had them stick to the base when temperatures fall below freezing while the camper was wet.

In one unique situation, an owner reported seagulls decided to tear it apart while beach camping.

This is one coil of material, enough to do one camper.  It will have to be cut into two parts for an E-Camper, one section for the main perimeter, and one for the rear inset at the rear hatch.

This seal has an EPDM foam rubber bulb. The bulb is hollow for compressibility and the foam has closed-cell construction, which resists absorption. These seals push into place to stop wind, dust, and water from entering. The gripping edges have fingers for a strong hold.

Specifications:

Install & Application

• These seals push into place to stop wind, dust, and water from entering. The gripping edges have fingers for a strong hold to the top.
• It is important to clean the fiberglass edge, removing any mildew, mold, dust or grime.
• Make sure the area is 100% dry for good friction when installing
• The core of the gasket is a U shape of aluminum. If the fit is loose, gently squeeze the edges make it grip tighter.
• There is no glue or adhesive needed for installation.

Application: